The content and information here is for entertainment and should not be taken as professional advice. ![]() All Rights Reserved.ĭisclaimer, Usage Policy, Privacy Policy & DMCA Policy. A cut-out feature in the back gains me 3 mph in wind survival.Įmail Newsletter Powered by AWEBER 2010-2023 © Tiny House Media LLC. Due to this target my trailer designed length is 6.5 ft with an inside height of 4 ft. My target of 74 mph might be on the high side. I have been trying to find out if there are regulations on industry standards on this so I can design my camper without over designing it. The wind load in lbs/sq ft = 0.0033 X V^2 where V is velocity in mph. With an area of 79 sq ft the force per sq ft = 535/79 = 4.5 lbs. So, a wind force of (1925 ft-lbs)/3.6 ft = 535 lbs will do it. When this equals 1925 ft-lbs it will begin to tip. The wind torque is equal to the wind force X 3.6 ft. What wind force does it take to produce a torque of 1925 lbs on this trailer? The torque needed to begin to tip the trailer is 700 lbs. The center-to-center tire spacing is 5.5 feet. The bottom of the trailer is 1.5 feet above the ground which puts the center of effort of the trailer wind load at 2.1 + 1.5 = 3.6 feet. The center of effort (where the wind force appears to be concentrated) for a half circle is (4r/3Pi) = 2.1 feet from the bottom. I am modeling the profile of your trailer as a half-circle having a radius (r)of 5 feet. Here are more exact calculations on wind tipping. If you enjoyed this post share it using the buttons below and talk about it in the comments. The finished product looks great and he is planning on doing it again so be sure to visit his blog.Īll Photos Courtesy of Jean-René Rodrigue Jene-René’s Teardrop Trailer / Micro Camper Project He kept it white on the inside, then he put it back together and sealed everything with silicon and butyl tape so that it’s watertight. To paint the micro camper, Jene-René took the walls apart and used a green urethane-based paint. Painting your teardrop trailer after construction Jene-René built his own door with a window and door latch that he ordered. If you’re building your own micro camper or teardrop trailer, you’ll need: Nothing really sticks to this material so it can’t be painted but this also means that bug splatter won’t stick either.Īdding necessary accessories for your home built micro camper It’s also lightweight compared to plywood. This material is great for resisting cold temperatures and it’s very flexible and is less likely to dent, ding, or kink. Jean-René chose ultra high molecular weight polyethylene plastic for the roof which he attached to the edges of the wall with stainless-steel screws. How to add a roof to your teardrop camper shell The walls are held together thanks to screwed planks at each end which you can see in the pictures below. This material is much lighter than plywood which is usually used for projects like this.Īnother benefit of using this material is that if exposed to moisture, it won’t rot. Inside there’s 1.5″ of foam sandwiched by two layers of epoxy coated fiberglass. He actually put this together in his apartment. How to construct walls for your teardrop trailerįor this project, Jean-René used composite materials for the walls. He followed up by painting it an aluminum color to make it look nicer. ![]() Jean-René got 8″ steel wheels and a 2,000 lb axle with leaf springs. ![]() He made the 5′ x 8′ trailer out of steel square tubing and angles along with a jack stand for each corner. I was impressed to find that Jean-René designed and created his own trailer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |